Has anyone had any luck getting wind info from the SN10 to the Oudie?
I'm getting good GPS info from the SN10 but the wind readout on the
Oudie is blank.

ILEC is set to "output to PDA" and at 4800 baud rate.

Oudie is set to Com4 (serial cable) at 4800 baud rate, parity none, 8
bits, stop bit 1. On Hardware page Ilec SN10 is the selected device
and all boxes below are checked.

Thanks for any help.

G

Again:
- Oudie is definitely receiving GPS position from SN10
- no wind is received.

Does anyone know if Oudie implements:
http://www.nadler.com/sn10/SN10_PDA_Support.html

Thanks,
Best Regards, Dave "YO electric"